CLOTHING PATTERNS & TUTORIALS
T- TUNIC TUTORIAL
13TH CENTURY TUNIC TUTORIAL
WIDE-SLEEVE GOWN TUTORIAL
EASY LACED GOWN TUTORIAL
OR GOWN TUTORIAL
EARLY HOOD TUTORIAL
WITH SHOULDER GORES TUTORIAL
SIDELESS SURCOTE TUTORIAL
Sideless Surcote Tutorial with 2 side gores
Re-enactors can also use this pattern. This is an overdress and always
has something with long, fitted sleeves underneath. Make it from linen
or wool for day wear. Made if from silk for fancy formal events. If
you're a noblewoman, it can be cut away quite a bit to show off your
You need: your fabric, pins, scissors and a cotton shirt for sizing.
Don't use a stretchy one as it can give a false sense of how it
will fit you.
If you don't have a cotton shirt, get thee to an Op Shop and spend
a couple of dollars and get one.
Lie your fabric flat on the floor unfolded.
Fold your shirt and your fabric in half lengthways with the fold
on the left hand side. The good side of the fabric is on the inside.
If you arm goes to the edge of the fabric, HOORAY, you can make
this with very little fabric at all. If your fabric is skinny, you
will need to fold your fabric double (two runs of fabric instead
of a folded over piece) before you begin.
Your folded shirt matches the side with the folded fabric.
Fabric fold check! Your fold is on the left side. Your loose sides
are on right. Your shirt is sitting right in that corner at the
top ready to mark out your surcote.
Marking out your pattern. This is not quite so terrifying as it
Always ALWAYS cut the seams a bit bigger than you think you need.
You can always take a dress in but it's really hard to add pieces
in once it's cut.
You mark your seam from the edge
of your shoulder straight down to your belly button and then curve
out to your hip where the dotted red lines are and then out to
the fabric edge for the skirt.
You will need to mark out 2 of them. You can cheat by cutting
out one and simply tracing around it to make the other one. The
bottom one will be longer at the bottom.
To get the size of your skirt, draw a line from the hip (the bottom
of the shirt) to the very edge of the fabric. The wider your fabric,
the more skirt you'll have.
Your centre seam is as long as you are to the ground. If you want
a train, allow more. You have room to also cut some triangle gores.
Okay, start pinning!
Just double check again that the fabric is folded the right way
before you cut anything..
.. . it should look like this...
Cut your new surcote out.
Unpin the sides now that your dress is cut.
It looks like this.
Swing your triange gores around so the top of the triangle is at
the waist and the bottom of the triangle lines up with the hem.
You may need to trim your triangle to fit the sides, but that okay.
Just trim all four of them together so they are the same size.
Check that you have front and back.
Unfold the surcote so you can clearly see your pieces.
It looks like this.
One piece is longer at the bottom. This is your back.
You have 4 little triangle gores which go at the sides.
Pin pin pin them onto the sides of your surcote pieces!
Remember, the GOOD side of the fabric faces the good side of the
fabric. You are pinning on the underside, so the seam is inside
when you're finished.
Swing one piece around 180 degrees so the shoulder pieces are touching.
Make sure your fabric is the same way out so you have the two good
When it's spread out of the floor, it looks like this.
The side you want to be the front is the one without the train.
Cut the neckline a little lower. Just a little. Remember, you can
take more off, but it's really hard to put it back on. Okay so now
you have a front.
You will want to adjust the front of your surcote so it is not as
wide as the back. Do that at the very end so you are allowing for
Pin the shoulders together, remember to check the good side of the
fabric is facing the good side of the fabric. You want your sewing
on the wrong side, so the good sides face inwards.
Okay, now fold your surcote so it looks like a surcote. It looks
like the pic. Turn it inside out and pin, pin, pin those side seams
all the way from the hem to the hip.
ALWAYS pin and try on before you sew. It beats the heck out of unpicking
Once you're happy with the fit and you've adjusted your neckline,
sew your two side seams and you're finished!
Now is the time to trim the front of the surcote a little if you
want a really cutaway garment. Remember, you need to allow enough
fabric to do a rolled hem around the side openings.
Hem the sides and hem and you're finished!
Shown here, I've made the surcote in linen to wear over other clothes
when I'm busy in the mornings and I'm cooking and cleaning and setting
up for the day. It does the same job as an apron keeping my things
clean. I've made it with a hem that barely reaches the ground.
The top picture is the exact same pattern but made from silk lined
from silk with a longer train and gold metal braid at the edges.
It's lined with linen, and the linenone is unlined>
It's hard to believe it's the same pattern, but it really shows
what a difference a change of fabric and accessories makes to a
You can also line this surcote with a contrasting colour. All you need
to do is cut two of these together and sew them together. If you are
doing this, just be aware that sewing the armholes can be a bit perilous.
Do them one at a time. Do the neck seperately. Do the hem last of all.